Ice i20B, Руководство оператора и каталог запасных частей

Страница: 6 / 29

ICE i20B 6
OPERATOR MANUAL
MACHINE SET UP & INSTALLATION
UNPACK MACHINE
Be sure and check packing carton for any
damage. Immediately report any damage to
carrier. Be careful not to let machine vibrate
while carrying, Check contents of package to
ensure that the following items are included:
• Machine
• Squeegee assembly
• Brush and pad driver
• Battery charger
• 2-12V Batteries
INSTALLING BATTERIES
You will need to connect the cables to the
battery posts before operating the machine.
WARNING:Batteries may emit
hydrogen gas. Explosion or fire can result
from hydrogen gas. Keep sparks and open
flames away! Keep battery compartment
open when charging.
1. Turn the main power key switch off.
2. Open recovery tank to gain access to battery
compartment.
3. Carefully place the two batteries into the
compartment as shown in figure below.
Place the battery brace to the rear of the two
batteries. DO NOT DROP BATTERIES INTO
THE COMPARTMENT DIRECTLY.
4. Connect battery cables to posts in numbered
order as shown in drawing below.
RED to POSITIVE, BLACK to NEGATIVE
MACHINE SET UP
PRE-OPERATION CHECKS
1. Sweep the outside of the machine.
2. Check battery meter to make sure batteries
are fully charged. (See BATTERY CHARGING)
3. Make sure the squeegee is properly installed.
4. Check that brush / pad driver is properly
installed.
INSTALLING BRUSH OR PAD DRIVER
1. Ensure that the machine is turned off.
2. Step on the scrub head lifting pedal (see
machine components, item #9) to raise the
scrub head off the floor.
3. If using a pad driver, attach the appropriate
pad to the pad driver surface first.
4. Turn the brush motor hub until the slot with the
spring clip is visible through the scrub head
window.
5. Mount the pad drive or brush to the brush
motor hub by lining up the three studs with
the three holes in the hub. Once in the holes,
rotate the brush / pad driver toward the spring
clip to lock the pad driver into place.
NOTE: If necessary, press down the motor hub
locking pin (see machine components, item #33)
to lock motor hub in place.
INSTALLING SQUEEGEE ASSEMBLY
1. Lift the squeegee lifting level (see machine
components, item #26) to the upward position.
2. Mount the squeegee assembly to the
squeegee pivot bracket. Make sure the knobs
are completely seated into the slots before
securing knobs.
3. Connect the vacuum hose to the squeegee
assembly. Loop the hose by using the hose
clip provided.
4. Check the squeegee blades for proper
adjustment.