15
View the rear derailleur and pulleys from behind
the rear wheel. Turn the limit screw marked ’H’
on the outer link of the derailleur to align the
upper guide pulley centre with the outboard
edge of the smallest cog. Then, push the rear
derailleur towards the larger cogs by hand.
Align the upper guide pulley under the largest
cog, centre to centre, by turning the limit screw
marked ’L’ on the outer link. The final
adjustment will take place once the chain is
installed.
Fit the long length of gear outer casing into the
rear derailleur.
Check that the rear derailleur is in the smallest
cog position. Rotate the rear shifter to the ‘9‘
position. Turn the rear shifter barrel adjust
clockwise fully into the shifter, then back it off 1
full turn.
Thread the rear derailleur cable through the
rear derailleur housing stop and through the
cable guide on the fin. Pull the cable tight and
position it under the cable anchor washer.
Tighten the 5 mm hex cable anchor bolt to 35 –
45 in.lbs. (4 – 5 Nm).
