
Plug the Roner20 into a power outlet.
The “Start / Stop / Enter” icon (hereinafter “Enter”) and the
front led will be on and in standby mode (This mode is
identified by the word “manual” in an off tone on the
screen) Press the “Enter” icon during 3 seconds to enter
work mode. You will hear a beep for each press.
And the "manual" message will change to a livelier tone.
4.1 MANUAL MODE:
Temperature setting.
Press "Enter" and the temperature digits will flash.
Adjust the degrees with "+" or "-" and press ">" to move to
the next parameter.
* Press and hold "+" or "-" to start fast mode both up and
down.
Setting time.
Press "+" or "-" to set the hour and press ">" to move to the
minutes.
With “+” “-” set the minutes and press “Enter”.
The Roner20 will start up. While the water is heating up, the
front led will blink red.
The timer will begin a countdown when it reaches the pre-
set temperature, emitting two beeps and turning the red
Led, from blinking to steady.
When you reset the temperature either up or down, you
need to wait a while to reach and stabilize the bath water
temperature to start the timer.
8