myDVR1630/930 Operational Guide
shows the maximum frame rate for NTSC/PAL video.
Resolution
Max. Frame Rate
320x240 120/100
FPS
704x240 30
FPS
704x480 30
FPS
QUALITY
Configure the recording quality for a specified channel.
Netork, Standard, High, Super, Ultra.
Video quality is the best for “
Ultra
” (Network quality is
designed for very low upload bandwidth conditions (i.e.
weak WAN connections)
RECORDING
Assigns the recording method for a channel:
Disable, Continuous, Motion, Sensor or Schedule
.
MOTION ZONE
Sets full zone or partial zone.
MOTION SENSITIVITY
Sets motion detection sensitivity for a specified channel.
from 1 to 9.
(9 is the most sensitive setting.)
SENSOR RECORDING
Configures Alarm/Sensor Inputs for triggered recording. In
total there are 16 sensors (9 for myDVR930). A maximum
of 4 sensor/alarm inputs may be assigned to an individual
channel.
PRE RECORD
Enables/disables pre-alarm (pre-event) recording. Pre-
alarm recording is 5 sec. Only intra-frames are recorded.
POST EVENT RECORD
Set the length of time for post event recording video (post
alarm recording). Configure by channel from 1 to 30
seconds.
AUDIO
Enables/disables audio by channel.
There are 4 channels
of line level audio inputs and a single line audio output.
SCHEDULE
Configures record schedules. Launches new menu as
shown in Figure 3.3.3.
3-3-1. Setting up Motion Zones
By selecting
Partial
Zone
, users can define motion zones within a screen area, as
shown in Figure 3.3.1. Move each rectangular zone around using the four direction
key buttons. Press the
SELECT
button to save the defined rectangular region as part
of the motion zone. Upon saving, the defined rectangular blocks will change color.
Preliminary
17
Content subject to change without notice.
