ICANCLAVE STE-18-D, Инструкция по эксплуатации

Страница: 10 / 25

10
Drain the distilled water tank
Attach the drain hose on a fitting connection located on the front of the sterilizer. Pull the
connector to start the draining.
Attention: The capacity of the distilled water tank is approximately 2.5 liters.
Drain the used water tank
Attach the drain hose on a quick fitting connection located inside the service door at the left.
Attention: The capacity of the used water tank is approximately 2 liters.
Preparation of sterilization materials
For the most effective sterilization and to preserve the sample, please follow below:
Clean instruments immediately after use.
Treat the instruments by ultrasound cleaner.
Residual chemicals left over after cleaning and disinfecting process may damage and
corrode parts of the sterilizer, always rinse off the instruments using distilled water.
Follow instrument manufacturer’s guidelines and recommendations for handing and
cleaning instruments prior to sterilization.
Check the manufacturer’s instructions as to proper procedure for sterilizing of each item.
Arrange the samples of different materials on different trays or with at least 3cm of space
between them.
Clean and dry instruments thoroughly before placing them into tray.
Always insert a sterilization paper or cloth between the tray and sample to avoid direct
contact.
Arrange the containers (glasses, cups, test-tubes, etc.) on one side or inverted position,
avoiding possible water stagnation.
Don’t stack the trays one above the other or put them in direct contact with the walls of
the sterilization chamber.
Always use the instrument tray handle.
Wrap the samples one by one or, if more tools have to be set in the same bag, verify that
these are made of the same material.
Don’t use metallic clips, pins or other, as this jeopardizes the maintenance of the
sterilizer.
Don’t overload the trays over the stated limit (see appendix 2).