ICA TURBOJET PLUS, Инструкция по эксплуатации, Страница: 19 / 23

19
ENGLISH
Installation instruction:
8. Assemble valve base
Replace the valve base in its position, make sure the valve base handle is
in the “unlock” position.
9. Lock valve base
When the valve base is set to
position, push the valve base
handle back to the “lock” position.
Inlet
pipe
minimun
water level
Tubing
In
Screw
Out
Tubing
12cm
Elbow
Outlet
pipe
10. Assemble flexible tube
Connect the tubing to the inlet and
outlet pipes, at least 3cm depth.
11. Assemble shower pipe/
directional spout
*Method 1: connect the shower
pipe to the outlet pipe.
*Method 2: connect the directional
spout to the outlet pipe.
12. Set up outlet pipe
Fix the spray bar in position with
suction cups.
13. Set up inlet pipe
Introduce the inlet pipe in the tank,
fix the pipe with a suction cup.
The strainer must be below the
minimum water level.
14. Set up the valve tap hose
Connect the inlet tubing to the
valve marked with “in” and outlet
tubing to the valve mark with
“out”. Tighten the tubing with the
screws.
15. Pumping
Grasp the pumping handle and
move up and down 2-4 times,
then the water in the tank will be
sucked into the canister. *The
distance between the aquarium
edge and the water level should be
under 12cm.
open
lock
lock