IC Realtime ICHD850VDIR, Инструкция по эксплуатации

Страница: 5 / 16

8 9
5. Installation
5-3. How to reposition the cable from the back to the side of base. 5-4. How to adjust the Zoom/Focus.
5. Installation
ྙ DRW 3-1 shows cable connection for factory default set up. The cable comes out through
the back of camera base.
ྚ Unscrew the 2P power lead wire. Then, unplug the 2P wafer CVBS output & MCX cable
for HD-SDI output.(DRW 3-2) respectively.
ྛ Unscrew the cable tie and the wire (Hanger) as in the DRW 3-3.
ྜ Pull out the Cable, O-Ring and Hanger from the base as in DRW 4-1.
ྜྷ
Take off the conduit cap with a coin as in DRW 4-2. Please reuse the conduit cap to
cover the conduit hole at the bottom of the base.
ྞ
Put the cable into the base through the side conduit hole as in DRW 4-3.
ྟ Fix the cable and the safety wire (Hanger) with cable tie and screw as in DRW 4-4.
ྠ Connect 2P power cable, 2P CVBS wafer and MCX HD-SDI cable respectively to
PCB Board as in DRW 4-5.
a. Parts location
b. Zoom/Focus adjustment
Zoom and focus locking levers are screwed up and positioned at top side so that they can
be accessed by hand at factory.
1. Please loosen the zoom/focus locking levers a little bit by turning them counter-clockwise
with finger.
2. Move the lever left or right to adjust the zoom and focus.
3. Please lock them tightly after the adjustment by turning them clockwise with finger.