Page 11
Page 12
Output 1-Local High Start
Output 1-Local High & Low Start
Output 2-Remote High Alert
Output 2-Remote High & Low Alert
The CTD comes pre-programmed to work with the Chilly Dog system.
The settings allow for two high triggers that output to the main control
module. The first is designated to output 1 and is used to activate the
temperature controlled startup, The second is designated to output 2
and is used to activated the High temperature alert. The Chilly Dog
can also be set to start the vehicle or alert based on low temperatures.
See Parameter setting 9 & 10 (Output 1 & Output 2 map designations)
Output 1 = Temperature Controlled Startup
Output 2 = Temperature Activated Alert
Default
Expanded (High & Low Temperature Start)
Expanded (High & Low Temperature Alert)
Note:
If using a window drop module in low temperature alert mode, the windows will roll
down when the low temperature is reached.
Table for Output(s) Map Designation Expanded
Programming the Temperature Thresholds
To enter Programming Mode;
Remover the CTD cover.
Press and release the programming button located on the CTD.
Press and release this button to scroll through the 15 parameters.
There are two independent temperature settings that trigger Activation Mode
(Local High Start Output 1),andtrigger Alert Mode (Remote High Alert Output 2).
The factory default settings are Local Start 79, and Remote Alert 99.
There are 15 programmable parameters for the CTD that adjust the following:
Parameter
Display
Default
Min
Max
Fahrenheit or Centigrade
Remote Probe Enabled
Display Local or Remote Probe
Set Local Low Limit
Set Local High Limit
Set Remote Low Limit
Set Remote High Limit
Select Output Mode
Map for Output 1-See Table
Map for Output 2-See Table
Set Alarm Delay for Relay 1
Set Alarm Delay for Relay 2
Enable Local Buzzer
Local Buzzer Silence Time
Reset Degrees
Use these buttons to view
and change the Default
Settings.
