8
Manual ISM
–
usb.1 / .2
When the selections concerning the PC - connection and the IBR - instrument have been made, the
columns
Connection
and
Gauge / Sensor
are filled and displayed as shown below.
Note :
If a (*) appears behind the entry IBR-ISM, then the ISM module was not found
( e.g. no driver installed, the IBR-ISM
is used by another software, … ).
The gauge radio modules can be individually either activated or deactivated for operation with a
particular PC - Radio station. In order to do so, please click the
on ( off )
- button of the radio module
concerned. The button is located directly on the right - hand side of the
Gauge / Sensor
column.
This programming possibility allows simultaneous operation of several PC - Radio stations with up to
120 radio modules.
The addresses 121…499 can be assigned via the Setup buttons of the respective
channels.
By clicking on the
OK
- Button the settings are confirmed and the window is closed.
As a result, the display window of
IBR_SimKey
is opened and you can begin with transmission of
measurement data. The display window is shown below.
Now, measurement data can be transmitted to the PC by pressing the data key on the gauge
( if available ), or on the radio module.
