10
Manual ISM
–
usb.1 / .2
In the upper left - hand area of the programming window you can find the selection column containing the
commands available for programming. The selection column containing the appropriate parameters is
located directly to the right of it.
For programming please select the command to be executed and then the desired parameter. By clicking the
OK
- Button the chosen command is loaded into the transmission buffer. Now, please press the data key of
the radio module which is to be programmed, in order to trigger measurement data transmission. On the end
of the measurement data transmission the PC - Radio station sends the chosen command from the
transmission buffer to the gauge radio module. The radio module confirms successful programming by a short
tone sequence and a triple flash of the green LED.
Overview of commands for programming gauge radio modules :
Command
Description
Values ( range )
Set factory settings
Resets all adjusted parameters back to factory
settings. These are marked by a (*) in the parameter
list.
-----
Set Module Address
Serves to select the sender address of the radio
module that is to be programmed.
Note :
Please use only addresses 1…499 for
measurement operation !
From 1 to 500.
Permanent Mode - Value number
( IBRit-rf1 legacy mode )
Defines how many measurement data records are to
be transmitted automatically in the Permanent Mode.
The Permanent Mode is started by pressing the data
key on the radio module.
Note: Using the Permanent Mode can reduce the
lifetime of the module's battery.
From 0 to 255
values.
Permanent Mode - Interval time
( IBRit-rf1 legacy mode )
Defines with which time interval the data records are
to be transmitted automatically in the Permanent
Mode.
Note: Using the Permanent Mode can reduce the
lifetime of the module's battery.
From 1 to 256
seconds.
Transmission confirmation ( o.k. ) -
Flash-Time ( green )
Defines the period of time during which the green
LED is lit ( on transmission confirmation by the radio
module ).
From 0 to 2150
milliseconds.
Transmission confirmation ( o.k. ) -
Beep-Time
Defines the period of time during which the buzzer
beeps ( on transmission confirmation by the radio
module ).
From 0 to 250 /
frequency.
Transmission confirmation ( o.k. ) -
Beep-Frequency
Defines the beep tone - frequency of the buzzer beep
( on transmission confirmation by the radio module ).
From 500 to
2000 Hz.
Transmission error -
Flash-Time ( red )
Defines the period of time during which the red LED
is lit ( on error signal by the radio module ).
From 0 to 2150
milliseconds.
Transmission error -
Double-Beep-Time
Defines the period of time during which the buzzer
beeps once ( on error signal by the radio module ).
From 0 to 250 /
frequency.
Transmission error -
Double-Beep-Frequency
Defines the beep tone - frequency of the buzzer beep
( on error signal by the radio module ).
From 500 to
2000 Hz.
Continued on next page.
