CamBoss
14 / 19
Replacement of windshield of the camera
If the operating personnel have sufficient training, the damaged glass may be replaced,
otherwise contact the IBOS a.s. service centre for technical support. To replace the camera
windshield:
•
Unscrew the front camera cover;
•
Carefully remove the windshield or any glass residue from the camera head;
•
Fit new O-ring seal;
•
Insert the new windshield and install the front cover back;
15. Cleaning
•
After inspection, spray the trolley, camera, sliding runners and roller runners
thoroughly with water before releasing. Never use pressurized water.
•
Immediately close any retractable and screw connectors with the supplied
protective caps and allow the individual components to dry.
•
Clean the camera cable by letting it to run through a damp cloth while winding.
•
Clean parts only with a damp cloth (water, mild detergent).
•
Clean the camera lens with a tissue for cleaning of spectacle, do not use paper-
type one, to avoid scratching the camera's windshield.
Shipping of damaged system components
If repairs to system components are necessary, in addition to the work described in these
operating instructions, send all equipment components to IBOS a.s. customer service, so that
all components can be tested during the troubleshooting and set and update the control unit,
when necessary. Observe the following points:
•
Secure the connectors with the appropriate plug to prevent damage;
•
Ship components in clean state, carefully wrapped and preferably in original
packaging;
•
Add accurate defect description;
Device decommissioning and disposal
Follow national regulations for decommissioning, disposal and reuse of
device. Contact the appropriate authorities responsible for
environment protection (according to waste, special waste and residual
materials laws and regulations).
Содержание CamBoss
Страница 3: ...CamBoss 2 19 CamBoss flow chart ...
