OPERATION MODE:
With the use of operation mode switch, the user can select one of eleven modes by
consecutive pressing. The operation modes are classified into five setpoint groups.
Selection of one group is displayed by the light of the appropriate signal lamp in
the panel of the pump. By consecutive pressing of the operation mode switch, a
user can go through all setpoints, and within them through different operation
modes. The information on current active operation mode will be displayed for a
short time on the screen of power consumption meter mode upon pressing the
operation mode switch.
Information displayed on the screen of the meter:
AU - automatic pump parameter selection according to the installation needs
(diagram - grey colour)
∩1- constant speed, the lowest first gear (diagram - black colour)
4
The powering installation of the pump must be equipped with a
residual current device, with rated making current In not exceeding 30
mA. The manufacturer and guarantor are not liable for any damage to
people or property resulting from supplying the pump with power
without a proper switch.
PUMP OPERATION CONTROL:
Upon launch of the pump the display of the power consumption meter will show
the current power consumption of the pump. When the message “--” (two
horizontal lines) is displayed, it means that the pump is blocked. In this case the
pump must be disconnected from the electrical grid, unblocked (failure must be
eliminated) and turned on again. Turing off and again on resets the failure
message.
Operation mode signalling
unit according to fixed
gears, 1, 2, 3
Signalling unit of
automatic mode of
parameter selection
according to installation
needs
Operation mode switch
Current
consumption
meter display
Night mode switch
Night mode signalling unit
Signalling unit for operation acc. to
proportional pressure PP1 PP2, PP3
characteristics
Signalling unit
for operation acc. to constant
pressure CP1.CR2.CP3
