in the pipeline. It is recommended to flush the pipeline in which the pump is
installed prior to installation.
The
pump
must
be
installed in such a manner
that its shaft is in a
horizontal position. Ports
can be in a different
position than shown in
this picture, however, the
motor shaft must always
be in a horizontal position.
Installation of the pump in a manner where the shaft is in vertical position results
in fast wear and tear of the bearings and failure of the pump. In such a case, only
paid repair is available.
The arrow cast on the corpus indicates the direction of water flow.
The pump should be installed in such a manner which allows for cable inlet
in the control panel box was placed in the bottom. This type of installation protects
against water penetration into the cable box in case of leakage in the water
installation. Device destruction caused by pouring water into the terminal box
from the outside is not subject to warranty repair.
Despite the possibility of pump operation in water pumping in a vertical downward
direction, the manufacturer recommends the installation which makes it pump
water vertically upward or horizontally.
ELECTRIC CONNECTION:
The electric network used to power the pump must be compliant with data
provided on the rating plate. The pump is fitted with a cable with a plug intended
for its connection to the socket with earthing.
The pump must be connected to a network with active earthing.
The manufacturer and guarantor are not liable for any
damage to people or property resulting from lack of proper earthing.
3
Vertical
motor axis
WRONG !
Horizontal
motor axis
GOOD !
