IBM xSeries 300, Руководство по техническому обслуживанию аппаратной части

Страница: 50 / 120

Note: The illustrations in this document might differ slightly from your hardware.
PCI slot 1
(PCI 1)
PCI slot 2
(PCI 2)
Adapter considerations
Before you install adapters, review the following:
v
Locate the documentation that comes with the adapter and follow those
instructions in addition to the instructions in this chapter.
v
If you need to change the switch settings or jumper settings on your adapter,
follow the instructions that come with the adapter.
v
You can install 32-bit full-length or half-length adapters in the expansion slots.
Full-length adapters are installed in slot 1 only; half-length adapters are installed
in either slot 1 or 2.
v
Your server supports 5.0 V and universal PCI adapters; it does not support 3.3
V only adapters.
v
Your server uses a rotational interrupt technique to configure PCI adapters. You
can use this technique to install PCI adapters that currently do not support
sharing of PCI interrupts.
v
The system scans PCI slots to assign system resources. By default the system
starts (boots) the CD-ROM and diskette drives first. Then it starts PCI slot 2, PCI
slot 1, and the integrated Ethernet.
Note: You can use the Configuration/Setup Utility program to change the boot
precedence for your server. Select
Start Options from the
Configuration/Setup Utility program main menu.
Installing an adapter
Complete the following steps to install an adapter:
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see “Handling
static-sensitive devices” on page 37.
42
Hardware Maintenance Manual: xSeries 300