IBM x3800 - System - 8865, Руководство по установке

Страница: 25 / 88

1. Read the safety information that begins on page v and “Installation guidelines”
on page 7.
2. If you are installing drives in a tower model, remove the front cover (see
“Removing the front cover (tower model only)” on page 10).
3. Remove the filler panel from one of the empty hot-swap bays.
4. Make sure that the tray handle is open; then, install the hard disk drive into the
hot-swap bay.
Notes:
1. When you turn on the server, check the hard disk drive status LEDs to make
sure that the hard disk drive is operating correctly.
If the amber hard disk drive status LED for a drive is lit continuously, that drive
is faulty and must be replaced. If the green hard disk drive activity LED is
flashing, the drive is being accessed.
2. If the server will be configured for RAID operation using an optional ServeRAID
controller, you must configure the disk arrays before installing the operating
system. See the ServeRAID
™
documentation on the IBM ServeRAID Support
CD for additional information about RAID operation and complete instructions
for using ServeRAID Manager.
If you have other options to install or remove, do so now; otherwise, go to
“Completing the installation” on page 25.
Installing additional DIMMs
The following illustration shows how to install a dual inline memory module (DIMM)
on a memory card.
The following notes describe information that you must consider when installing
DIMMs:
v
You can configure your server to use memory mirroring and memory scrubbing.
For detailed information about configuring your server and using these features,
see the User’s Guide on the IBM System x Documentation CD.
v To use the hot-add and hot-swap memory features, you must reconfigure your
server using the Configuration/Setup Utility program. See the User’s Guide on
the IBM System x Documentation CD for additional information.
v
DIMMs can be hot-added to the server once without having to reconfigure the
server. If you hot-add additional DIMMs to the server, you must reconfigure your
server using the Configuration/Setup Utility program.
Chapter 2. Installing options
13