IBM x3655 - System - 7985, Руководство пользователя, Страница: 50 / 118

Riser card assembly
Remote Supervisor Adapter II SlimLine
Riser card
Retainer bracket
To install a Remote Supervisor Adapter II SlimLine, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 23.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables (see “Turning off the server” on page 13); then, remove the
cover (see “Removing the cover” on page 26).
3. Remove the riser-card assembly (see “Removing the riser-card assembly” on
page 26).
4. Turn the Remote Supervisor Adapter II SlimLine card so that the connector
aligns correctly with the connector on the riser card.
5. Install the end of the adapter without the connector first. Slide the adapter under
the tabs; then, slide the holes in the adapter onto the pins on the retainer
bracket.
6. Rotate the free end of the card down under the tabs and onto the pins on the
retainer brackets; then, press the card into the connector on the riser card and
make sure that all the tabs on the latch brackets secure the card in place.
7. Replace the riser-card assembly (see “Installing the riser-card assembly” on
page 28).
See the documentation that comes with the Remote Supervisor Adapter II SlimLine
for information about installing the firmware and configuring the adapter. Create a
backup copy of the configuration so that if you need to replace the adapter in the
future, you can restore the configuration.
Note: When you start the server for the first time after you install a Remote
Supervisor Adapter II SlimLine, the start-up process will take several minutes longer
than a typical start-up.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 61.
Replacing the ServeRAID SAS controller
The following illustration shows how to install the ServeRAID-8k SAS Controller.
36
System x3655 Type 7985: User’s Guide