IBM TotalStorage Ultrium 3580 L23, Руководство по настройке и эксплуатации

Страница: 114 / 149

Installation
1.
Remove the side panels, if they are installed and designed to be removed.
a. If the side panel is locked, unlock it.
b. Slide the two side panel latches down to release the top of the side panel.
c. Tilt the top of the sides away from the rack and lift the side panel off the
rack.
2. Decide at what level you want to install the shelf.
Note: All vertical rack measurements are given in rack units (U). One U is
equal to 4.45 cm (1.75 in.). The U levels are marked on labels on one
front mounting rail and one rear mounting rail.
3. Install one cage nut on each front mounting rail. Install the cage nuts in the
bottom hole of the U level (just above the U-level mark), with the nuts toward
the rear of the rack. Make sure that you install the cage nuts at the same level
on the two mounting rails.
a. Hook one side of the cage nut clip into the square hole of the rackmount
rail.
b. Hold the cage nut in one hand and compress the cage nut clip with a flat
screwdriver blade.
c.
With the cage nut clip compressed, push the cage nut clip into the square
hole.
d. Release the screwdriver’s pressure on the clip. The cage nut is now locked
in the square hole.
4. Some racks are large and require extender brackets to be installed on the shelf.
Perform one of the following:
v
If you are installing the shelf in a rack that does not require extender
brackets, skip steps 5 through 11 on page 99.
v
If you are installing the shelf in a rack that requires extender brackets, go to
step 5 on page 99.
Figure 34. Installing a cage nut in the mounting rail
98
IBM 3580 Ultrium Tape Drive Setup and Operator Guide