IBM TotalStorage L10, Справочное руководство CLI

Страница: 53 / 96

Chapter 2. Configuration menu (root/config)
41
One-Step Zoning configuration menu (root/config/zone)
One-Step Zoning allows ports to be divided into multiple virtual zones (or work groups),
similar to Virtual Local Area Networking (VLAN). By separating activity on the network,
zoning also eliminates change notification propagation (change notifications that occur
within one zone cannot propagate to other zones.)
Use zoning to:
• Separate different operating system environments.
• Temporarily block or grant access during backup or other tasks.
• Consolidate equipment logically.
• Designate closed user groups for increased security.
• Separate test or maintenance areas from production areas.
Menu commands
Table 22. One-Step Zoning configuration menu commands
Command Description
Additional
Information
1. bzht Configures the Bad Zone Reset Hold Time setting. See page 42.
2. bzdt Configures the Bad Zone Delay Time setting. See page 42.
3. addprt Adds one or more port members to a zone. See page 42.
4. delprt Removes one or more port members from a zone. See page 43.
5. showmem Displays the port members within a zone. See page 43.
6. act Activates the zone set. See page 43.
7. deact Deactivates the zone set. See page 43.
8. zstate Displays the state of specified zone. See page 44.
9. zclr Clears one or more zones. See page 44.
10. addblk Adds an AL_PA blocking member to a group. See page 44.
11. delblk Removes an AL_PA block member from a group. See page 46.
12. showblks Displays the AL_PA blocking groups. See page 46.
13. hz Configures the Hard Zone policy setting. See page 46.
14. bzr Configures the Bad Zone Recovery policy setting. See page 47.
15. alpas Displays the zone AL_PAs. See page 48.
16. .. Returns to the previous menu. See page 10.
17. ? Displays additional information on a command. See page 10.