IBM TotalStorage FAStT EXP700, Инструкция по установке, использованию и обслуживанию

Страница: 61 / 158

Complete the following steps to replace the hot-swap hard disk drives that you
removed:
1. Lift up on the handle and gently push the drive CRU into the empty bay until the
tray handle touches the storage expansion enclosure bezel.
2. Push the tray handle down into the closed (latched) position as shown in
Figure 19.
3. Repeat steps 1 and 2 to replace additional drives.
Continue with “Setting the interface options.”
Setting the interface options
The storage expansion enclosure comes with two enclosure ID switches that are
used to identify the storage expansion enclosure on a fibre channel loop, and to
assign physical addresses to the drives. The enclosure ID switches are located on
the back of the storage expansion enclosure, as shown in Figure 20 on page 30.
e
xp70018
Figure 19. Replacing hot-swap hard disk drives
Chapter 2. Installing and cabling the storage expansion enclosure
29