IBM TotalStorage 3580 L33, Руководство по установке, эксплуатации и обслуживанию

Страница: 83 / 143

Table 13. Error codes on the Single-character Display (continued) . To clear error and cycle power, press the Unload
Button for ten seconds. A drive dump will be created.
Error Code Cause and Action
A
Tape drive hardware problem. The tape drive determined that a problem occurred which
degraded the operation of the tape drive, but it did not restrict continued use. If the problem
persists, determine whether the problem is with the drive or the media.
Note: The drive is usable, though the Single-character Display continues to indicate an error and
the Status Light flashes amber. The error code may clear when you cycle power to the tape drive
or place it in maintenance mode.
To determine if the problem is with the drive hardware, or the tape media, perform the following
procedures:
1. If possible, run the tape cartridge in a different drive. If the operation in the other drive fails
and
6
or
7
displays, replace the media. If the operation succeeds, run the Test Cartridge
& Media diagnostic (see “Function Code E: Test Cartridge & Media” on page 77).
2. If the Test Cartridge & Media diagnostic fails, replace the media. If it runs successfully, clean
the failing drive and run the drive diagnostics (see “Cleaning the Drive Head” on page 21 and
“Function Code 1: Run Drive Diagnostics” on page 69). If the drive diagnostics run
successfully, perform the operation that produced the initial drive error.
3. If the problem persists replace the drive.
If it is not possible to run the tape cartridge in a different drive, perform the following
procedures:
1. Clean the failing drive and run the drive diagnostics (see “Cleaning the Drive Head” on page
21 and “Function Code 1: Run Drive Diagnostics” on page 69). If the drive diagnostics run
successfully, run the Test Cartridge & Media diagnostic (see “Function Code E: Test Cartridge
& Media” on page 77).
2. If the Test Cartridge & Media diagnostic fails, replace the media. If it runs successfully,
perform the operation that produced the initial drive error.
3. If the problem persists replace the drive.
b
No error or message is assigned. See error code
8
in this table.
C
The tape drive needs to be cleaned. Clean the tape drive. See “Cleaning the Drive Head” on page
21.
The error code clears when you clean the tape drive or place it in maintenance mode.
d
No error or message assigned. See error code
0
in this table.
The Unload Button was pushed in and did not release. Verify that the button pushes freely.
Appendix A. Error Codes
65
|