IBM ThinkCentre 8129, Руководство по замене аппаратных средств

Страница: 27 / 36

Replacing the optical drive
Attention
Do not open your computer or attempt any repair before reading the “Important safety
information” in the Quick Reference that was included with your computer or in the
Hardware Maintenance Manual (HMM). To obtain copies of the Quick Reference or HMM , go
to http://www.ibm.com/pc/support/site.wss/document.do?lndocid=part-video.
This section provides instructions on how to replace an optical drive.
1.
Remove the computer cover. See “Removing the cover” on page 5.
2. Pivot the drive bay assembly upward to gain access to the optical drive
cables.
* X XXX X XX XX*
* X XXX X XX XX*
3. Disconnect the signal and power cables from the rear of the optical drive.
4.
Release the optical drive by pressing inward on the blue retainer at the side of
the drive.
5. Remove the drive by sliding it out the front of the drive bay.
6. Make sure the drive that you are installing is set correctly as either a master
or a slave device.
Chapter 2. Replacing hardware
19