IBM System x3650 M4 Type 7915, Инструкция по установке и эксплуатации, Страница: 146 / 192

Battery
Battery cable
connector
Note: The positioning of the remote battery depends on the type of remote
battery that you install.
b. Connect the other end of the battery cable to the battery cable connector on
the battery.
c. Place the battery retention clip underneath while pressing the release tab
toward the front of the server until it snaps in place to hold the battery
retention clip firmly in place.
Note: The battery must recharge for at least 6 hours under normal operating
conditions. To protect your data, the ServeRAID controller firmware changes the
write policy to write-through until the battery unit is sufficiently charged. When the
battery unit is charged, the ServeRAID controller firmware changes the write policy
to write-back.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 135.
Installing a USB hypervisor memory key
Hypervisor is a virtualization platform that enables multiple operating systems to run
on a host computer at the same time. Support for hypervisor is available with the
purchase and installation of an optional USB hypervisor memory key, with
embedded hypervisor software.
To install the USB hypervisor memory key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 40.
128
System x3650 M4 Type 7915: Installation and User’s Guide