IBM System x3100 M4, Инструкция по установке и эксплуатации

Страница: 56 / 108

Attention: Do not allow the server to fall over.
14. Connect one end of the applicable signal cable into the rear of the drive and
make sure that the other end of this cable is connected into the applicable
connector on the system board.
15. Route the signal cable so that it does not block the airflow to the rear of the
drives or over the microprocessor and dual inline memory modules (DIMMs).
16. If you have another drive to install or remove, do so now.
17. Install the air duct.
18. Install the side cover (see “Installing the side cover” on page 49).
19. Stand the server back up in its vertical position.
20. Install the bezel (see “Installing the bezel” on page 49).
Note: Remove the filler blocking the installed drive if any.
Bezel filler
21. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Installing a simple-swap hard disk drive
The server supports up to four 3.5-inch simple-swap SATA hard disk drives, which
are accessible from the front of the server. You must disconnect all power from the
server before you remove or install simple-swap drives. Before you install a
simple-swap SATA hard disk drive, read the following information:
v
Install the drives starting from the top bay to the bottom bay (bay 3, 4, 5, and
then 6). The following tables list the IDs of the hard disk drives:
Table 7. IDs of simple-swap drives
Drive bay ID
3 0
4 1
38
System x3100 M4 Type 2582: Installation and User's Guide