IBM System Storage TS2230, Руководство по установке, эксплуатации и обслуживанию

Страница: 95 / 141

until you see the end of the tape inside the cartridge. Then, slowly turn the
rewind tool counterclockwise to bring the tape edge toward the cartridge door
(
3
).
2.
Continue to turn the rewind tool counterclockwise until approximately 13 cm (5
in.) of tape hangs from the cartridge door. If necessary, grasp the tape and pull
gently to unwind it from the cartridge.
3. Remove the rewind tool by pulling it away from the cartridge. Set the tool and
the cartridge aside.
To remove the C-clip from the leader pin, refer to Figure D-7 and perform the steps
below.
1. On the leader pin (
1
), locate the open side of the C-clip (
2
). The C-clip is a
small black part that secures the tape (
3
) to the pin.
2. Remove the C-clip from the leader pin by using your fingers to push the clip
away from the pin. Set the pin aside and discard the clip.
To attach the leader pin to the tape, refer to Figure D-8 on page D-7 and perform
the steps below.
1.
Position the tape in the alignment groove of the leader pin attach tool (
1
).
Figure D-6. Winding the tape out of the cartridge. Turn the cartridge manual rewind tool clockwise to see the end of
the tape, then turn it counterclockwise to bring the tape to the cartridge door.
A67E0036
1
2
3
Figure D-7. Removing the C-clip from the leader pin. Use your fingers to push the C-clip from the leader pin.
Appendix D. Repairing a Cartridge
D-5