IBM System Storage TS2230, Руководство по установке, эксплуатации и обслуживанию

Страница: 81 / 141

Table A-1. Error codes on the Single-character Display (continued)
Error Code Cause and Action
A
Degraded operation. The tape drive determined that a problem occurred which degraded the
operation of the tape drive, but it did not restrict continued use. If the problem persists, determine
whether the problem is with the drive or the media.
Note: The drive is usable, though the Single-character Display continues to indicate an error and
the Fault light flashes. The error code may clear when you cycle power to the tape drive or place
it in maintenance mode.
To determine if the problem is with the drive hardware, or the tape media, perform the following
procedures:
1. If possible, run the tape cartridge in a different drive. If the operation in the other drive fails
and
6
or
7
displays, replace the media. If the operation succeeds, run the Test Cartridge
& Media diagnostic (see “Function Code E: Test Cartridge & Media” on page 3-16).
2. If the Test Cartridge & Media diagnostic fails, replace the media. If it runs successfully, clean
the failing drive and run the drive diagnostics (see “Cleaning the Drive Head” on page 3-6
and “Function Code 1: Run Drive Diagnostics” on page 3-9).
Once you begin this test, the diagnostic begins the loop sequence. Time the first loop by
pressing the Unload Button once to stop the diagnostic after the completion of the first loop,
then record the time it takes for the test to complete. Compare the recorded time with the
"Approximate Run Time" above. If the test runs successfully but the execution time is
significantly longer than the "Approximate Run Time", run “Function Code F: Write
Performance Test” on page 3-17. If the Write Performance Test fails, replace the media and exit
maintenance mode. If the drive diagnostics run successfully, perform the operation that
produced the initial drive error.
3.
If the problem persists replace the drive.
If it is not possible to run the tape cartridge in a different drive, perform the following
procedures:
1. Clean the failing drive and run the drive diagnostics (see “Cleaning the Drive Head” on page
3-6 and “Function Code 1: Run Drive Diagnostics” on page 3-9).
Once you begin this test, the diagnostic begins the loop sequence. Time the first loop by
pressing the Unload Button once to stop the diagnostic after the completion of the first loop,
then record the time it takes for the test to complete. Compare the recorded time with the
"Approximate Run Time" above. If the test runs successfully but the execution time is
significantly longer than the "Approximate Run Time", run “Function Code F: Write
Performance Test” on page 3-17. If the Write Performance Test fails, replace the media and exit
maintenance mode. If the drive diagnostics run successfully, run the Test Cartridge & media
diagnostic (see “Function Code E: Test Cartridge & Media” on page 3-16).
2.
If the Test Cartridge & Media diagnostic fails, replace the media. If it runs successfully,
perform the operation that produced the initial drive error.
3. If the problem persists replace the drive.
C
The tape drive needs to be cleaned. Clean the tape drive. See “Cleaning the Drive Head” on page
3-6.
The error code clears when you clean the tape drive or place it in maintenance mode.
d
Fiber AL_PA conflict. NOT SUPPORTED ON THIS DRIVE.
E
Fiber Port offline. NOT SUPPORTED ON THIS DRIVE.
F
Fiber Channel Error. NOT SUPPORTED ON THIS DRIVE.
J
Incompatible media. The tape drive detected an unsupported cartridge was loaded or the
cartridge loaded has an incompatible format. Drive will not accept an unsupported cartridge.
Appendix A. Error Codes and Messages
A-5