IBM System Storage N7000, Инструкции по установке и настройке

Страница: 9 / 20

5
2.1
Loosen (but do not remove) the four rai-adjustment screws on each rail.
Right rail
Left rail
Front of rack
Rear of rack
Rail adjustment
screws
2.2
Use the figure on the next page for reference. At the front of the rack,
position the right-hand rail into the rack at the appropriate EIA location
(make sure that the two locating pins seat properly). The bottom of the
rail should line up with the bottom EIA boundary.
When installed, each N7700/N7900 unit will occupy a 6U space.
Using two silver pan-head M5 screws, attach the rail to the front of the
rack using holes H2 and H8. Tighten the screws with a screwdriver.
Note:
2.3
At the rear of the rack, position the rail at the same EIA location used in
step 2.2 (make sure that the locating pins seat properly). Using two silver
pan-head M5 screws,
Tighten these screws with a screwdriver.
attach the rail to the rack using holes H2 and H8.
2.4
Tighten the four rail-adjustment screws on the installed rail.
Locating pins