IBM SAN50C-R, Инструкция по установке, обслуживанию и эксплуатации

Страница: 64 / 86

Removing an SFP Transceiver
About this task
To remove an SFP transceiver, follow these steps:
Procedure
1. Attach an ESD-preventive wrist strap and follow its instructions for use.
2. If a cable is installed in the transceiver.
a. Record the cable and port connections for later reference.
b. Press the release latch on the cable, grasp the connector near the connection
point, and gently pull the connector from the transceiver.
c. Insert a dust plug into the cable end of the transceiver.
CAUTION:
If the transceiver does not remove easily in the next step, push the
transceiver all the way back in and then ensure that the latch is in the
correct position before continuing.
3.
Remove the transceiver from the port.
v If the transceiver has a Mylar tab latch, gently pull the tab straight out (do
not twist), and then pull the transceiver out of the port.
v If the transceiver has a bale clasp latch, open the clasp by pressing it
downwards, and then pull the transceiver out of the port.
Note: If you have difficulty removing a bale clasp SFP+ transceiver, you
should reseat the SFP+ by returning the bale clasp in the up position. Then
press the SFP+ inward and upward into the cage. Next, lower the bale clasp
and pull the SFP+ straight out with a slight upward lifting force (see Figure
1-3). Be careful not to damage the port cage during this process.
SFP+ Transceiver with Mylar Latch rav00038
SFP+ Transceiver with Bale-Clasp Latch rav00039
40
SAN50C-R Installation, Service, and User Guide