IBM Redbooks x3850 X5, Инструкция по установке и эксплуатации

Страница: 96 / 148

Bezel
Alignment
tab
Alignment
tab
Release
tab
Release
tab
Removing the memory expansion module system-board tray
To remove the memory expansion module system-board tray, complete the
following steps:
1. Read “Safety” on page v and “Installation guidelines” on page 38.
2.
Turn off the host server (see “Turning off the server” on page 19) and all
attached peripheral devices. Disconnect all power cords from the memory
expansion module; then, disconnect all external cables from the memory
expansion module.
3. Remove the bezel (see “Removing the bezel” on page 47).
4. Grasp the blue release latches on the system-board tray handles and press the
release latches in opposite directions and rotate the handles to the fully open
position.
Stop-tab
Release latch
Release latch
Stop-tab
Handle
Handle
5. Grasp the handles and pull the system-board tray out until it stops; then, press
in the blue stop-tabs on both sides of the system-board tray and pull the tray
out of the chassis.
82
IBM System x3850 X5 and x3950 X5 Types 7145, 7146, 7143, and 7191: Installation and User's Guide