IBM Redbooks x3850 X5, Инструкция по установке и эксплуатации

Страница: 30 / 148

System-management connector: Use this connector to connect the server to a
network for systems-management information control. This connector is used only
by the IMM.
USB connectors: Connect USB devices, such as a USB mouse or keyboard, to these
connectors.
Video connector: Connect a monitor to this connector. In a two-node configuration,
connect the monitor to the primary server to see standard system output.
Serial connector: Connect a 9-pin serial device to this connector. The serial port is
shared with the integrated management module (IMM). The IMM can take control
of the shared serial port to perform text console redirection and to redirect serial
traffic, using Serial over LAN (SOL).
QPI ports 1 - 4: In a single-node configuration, use these connectors to insert either
a QPI wrap card or a filler panel. The QPI wrap cards enable increased
performance in certain models. In a two-node configuration, insert the QPI cables
in these ports to connect another server or a memory expansion module to your
server. See the documentation that came with your QPI cable kit for detailed
cabling instructions.
Gigabit Ethernet 1 and 2 connectors: Use these connectors to connect the server to
a network.
Rear view LEDs
The following illustration shows the LEDs on the rear of the server. For more
information about solving power-supply problems, see the
Problem Determination
and Service Guide .
16
IBM System x3850 X5 and x3950 X5 Types 7145, 7146, 7143, and 7191: Installation and User's Guide