IBM Power System IC922, Обслуживание

Страница: 55 / 190

Figure 33. Disconnecting the cables from the drive backplane
4. Determine where the PCIe adapter is plugged.
• If the PCIe adapter is plugged into the system backplane, continue with step “5” on page 41.
• If the PCIe adapter is plugged into a PCIe riser, continue with step “6” on page 42.
5. Remove the PCIe adapter from the system backplane by completing the following procedure.
a) Remove the tailstock screw using a Phillips #1 screwdriver and lift the PCIe adapter from the
system backplane as shown in the following figure.
b) If needed, label and remove any plugs or cables that extend out from the rear of the PCIe adapter.
Press the cable connector latch to unlatch the cable. Do not pull in the cables themselves; unplug
the cables by using the connector.
c) If needed, label and remove the cables from the PCIe adapter.
Press the cable connector latch to unlatch the cable. Do not pull in the cables themselves; unplug
the cables by using the connector.
Removing and replacing parts in the 9183-22X 41