IBM PCI Dual Channel Ultra3 SCSI Adapter, Инструкция по установке и использованию

Страница: 18 / 42

for assistance with Kerberos initialization. If the system administrator is unable
to help you, consult your support center.
If you need to install only a few nodes, use the
dsh -w host1, host2, host3...
command format to explicitly reference groups of nodes.
__ 5. To determine if the AIX operating system on each relevant node is at the
required level, type the following at the AIX operating system prompt:
dsh oslevel
OR
dsh -w <host1,host2> oslevel
Press Enter.
<host1,host2>
is a list of the host names for the nodes on which
the adapter will be installed. The required AIX level is 4.3.3 or later.
If the nodes are
not at a supported AIX level, upgrade the AIX level on the
nodes. Contact the system administrator for assistance.
__ 6. To determine if the PSSP level on each node is at the required level, type
/usr/lpp/ssp/bin/splstdata -G -b
, and then press Enter. The results display
for all nodes and are in a form similar to the following:
node# hostname hdw_enet_addr srvr response install_disk
last_install_image last_install_time next_install_image lppsource_name
pssp_ver
---------------------------------------------------------------------
1 eion01.ppd.pok.i 08005A75A6D4 0 disk hdisk0
default Thu_Dec__4_09:07:23 default <lppsource>
<pssp level>
<lppsource>
is the lppsource name for the node.
<pssp level>
is the PSSP
level installed on the node. The required PSSP level is 2.4 or later.
If the nodes are not at a supported PSSP level, upgrade the PSSP level on the
nodes. Contact the system administrator for assistance.
__ 7. Record the name that appears below
lppsource_name
for each node on which
the adapters are being installed. You will use this information later.
__ 8. To verify that the device driver is installed in the lppsource directory, type the
following at the system prompt:
cd spdata/sys1/install/<lppsource_name>/lppsource
<lppsource_name> was recorded in the previous step. Once you are in this
directory, verify that the fileset is in the lppsource directory by typing the
following at the prompt:
ls devices.pci.00102100.*
ls devices.pci.00100f00.*
ls devices.common.IBM.scsi.*
If the device driver is not in the lppsource directory, proceed to “Installing
Software on the Control Workstation” on page 10 to install the software.
8
Installation and Using Guide