4
Setup
This monitor works with platforms running at horizontal
frequencies between 30 and 94 kHz
Step 1: Connect your monitor to
your computer
Turn off the monitor and computer before connecting.
Note
Do not touch the pins of the video cable connector as this might bend the
pins.
Step 2: Connect the power cord
With the monitor and computer turned off, first connect the power
cord to the monitor, then connect it to a properly grounded power
outlet.
Step 3: Turn on the monitor and
computer
First turn on the monitor, then turn on the computer.
The installation of your monitor is complete.
If necessary, use the monitor’s controls to adjust the picture.
If no picture appears on your screen
• Check that the monitor is correctly connected to the computer.
• If CHECK SIGNAL CABLE appears on the screen, check the
input signal connection, and confirm that your computer’s
graphic board is completely seated in the correct bus slot.
• If you are replacing an old monitor with this model and OUT
OF SCAN RANGE appears on the screen, reconnect the old
monitor. Then adjust the computer’s graphic board so that the
horizontal frequency is between 30 – 94 kHz, and the vertical
frequency is between 48 – 170 Hz.
For more information about the on-screen messages, see “Trouble
symptoms and remedies” on page 11.
to computer
to video output
to AC IN
to a power outlet
power cord (supplied)
