IBM Nways 8260, Руководство по установке

Страница: 28 / 50

Mounting an E3, DS3, OC3, or STM1 on the WAN Motherboard
Attention: When installing an I/O card on the motherboard, be careful not to touch the
I/O card components. Always hold the I/O card by its edges.
Note: Although the illustrations in this chapter show an E3 I/O card being installed, the
steps are identical for the DS3, OC3, and STM1 I/O cards.
To install the I/O card on the WAN motherboard, follow these steps:
1
Before installing the I/O card on the module, you must first isolate and then
remove the module from the IBM 8260 Nways Multiprotocol Switching Hub,
IBM 8265 Nways ATM Switch, or IBM 8285 Nways ATM Workgroup
Switch. To isolate the module, enter the following command from the ATM
console:
SET MODULE slot ISOLATED
where
slot
specifies the number of the slot to be used.
2
Detach the motherboard on which you want to install the I/O card by
removing the four screws (
.1/
and
.2/
in Figure 10 on page 19) that hold
the motherboard to the module. Retain the screws for reattaching the
motherboard.
18
WAN 2/2.5 Modules: I/O Card Installation Guide