IBM Nways 8260, Руководство по установке

Страница: 20 / 50

Mounting an E1/T1/J1 or E1/T1/J1 IMA on the Motherboard
Attention: When installing an I/O card on the motherboard, be careful not to touch the
I/O card components. Always hold the card by its edges.
To mount the E1/T1/J1 I/O card or E1/T1/J1 IMA I/O Card on the motherboard, follow
these steps:
1
Before mounting the I/O card on the motherboard, you must first isolate
and then remove the module from the IBM 8260 Nways Multiprotocol
Switching Hub, IBM 8285 Nways ATM Workgroup Switch, or IBM 8265
Nways ATM Switch. To isolate the module, enter the following command
from the ATM console:
SET MODULE slot ISOLATED
where
slot
specifies the number of the slot to be used.
2
Detach the motherboard on which you want to install the I/O card by
removing the four screws (
.1/
and
.2/
in Figure 4) that hold the
motherboard to the module. Save the screws in order to reattach the
motherboard.
1
2
Figure 4. Removing the Motherboard
10
WAN 2/2.5 Modules: I/O Card Installation Guide