IBM NetVista, Быстрая справка

Страница: 29 / 76

2.
Use Windows Explorer or My Computer to display the directory structure
of your hard disk.
3. Open the ibmtools folder, which is usually on drive C.
4. Double-click RRDISK.BAT , and follow the instructions on the screen.
Using the Recovery Repair diskette
To use the Recovery Repair diskette, use the following procedure:
1. Shut down the operating system, and turn off the computer.
2. Insert the Recovery Repair diskette into the diskette drive.
3. Turn on the computer, and follow the instructions on the screen
Note: If the repair operation finishes without error, the F11 prompt will be
displayed the next time you restart your computer.
If an error message is displayed during the repair operation and the repair
operation cannot be completed, you might have a problem with the Product
Recovery program or the partition that contains the Product Recovery
program. See Chapter 5, “Getting information, help, and service” on page 27
for further information.
Changing the startup sequence
When your computer starts up, a configured list of startup (boot) devices
determines which devices and in what sequence they are checked. If your
computer does not startup (boot) from the expected device, the Startup Device
menu or the IBM Setup Utility can be used to select which device is checked
first in the sequence.
If you need to change the first startup device and there is no F12 prompt and
no Startup Device menu, use the IBM Setup Utility
1
. See “Using the IBM Setup
Utility” on page 16.
Using the Startup Device menu
Some computers have a Startup Device menu from which you can choose the
startup device. To use the Startup Device menu, do the following:
1. Turn off your computer.
2. When you turn on the computer, press and hold the F12 key until the
Startup Device menu is displayed.
Note: If the Startup Device menu is not displayed, your startup device
must be changed using the IBM Setup Utility. See “Using the IBM
Setup Utility” on page 16.
1. In some models, this program is called the Configuration/Setup Utility program.
Chapter 3. Recovering software
15