IBM Netfinity 5000, Руководство по установке и настройке

Страница: 18 / 24

4. Verifying Your Server Is Operating Properly
Use the following procedure to verify that your Netfinity 5000 server is operating
properly.
1
Turn on all external devices, such as your monitor, printer, and modem; then,
turn on your server. For the location of controls and lights, see the
illustrations on the following page.
Important
After you plug the power cord into an outlet, wait 20 seconds before
pressing the power switch. During this time the system-management
processor is initializing and the power-on switch does not respond.
2
Press the power switch on the front of the server. The power-on light comes
on and the power-on self-test (POST) begins.
3
Observe your monitor. When the system successfully completes its POST,
the server beeps once, the POST complete light comes on, and a prompt
appears on your monitor requesting that you insert startable (bootable) media.
Important
Ÿ
The following POST message might appear because the operating
system has not been installed.
1962 Drive does not contain a valid boot record
Ÿ
If you have added or removed options, POST message 164 appears
if configuration information has changed. Start the
Configuration/Setup Utility program and select Save Settings.
Ÿ
If any other error message appears, you hear more than one beep, or
your monitor screen is blank, refer to the “Problem Solving”
information in the “Hardware Information” section of this
Server Library
for instructions; then, return here and continue with “5. Installing
Additional Options” on page 16.
4
Continue with “5. Installing Additional Options” on page 16.
14
Netfinity 5000 Express Setup and Installation