IBM Netfinity 5000, Руководство по установке и настройке

Страница: 16 / 24

3. Cabling Your Server
Use the following procedure to attach the cables to your Netfinity 5000 server.
1
Select a location that will allow for air circulation. Be sure to maintain
minimum clearances around the server:
Front 102 mm (4 in.)
Rear 127 mm (5 in.)
Left and Right Sides 51 mm (2 in.)
2
Connect the device cables to the server. For the location of cable
connectors, see the illustrations on the following page.
Important
Ÿ
If you are attaching a modem or fax machine to the server and you
are in the United Kingdom, plug in the power cords first; then, connect
the telephone line to the wall outlet and the server.
Ÿ
To connect the server 10BASE-T or 100BASE-TX port to a hub, use a
UTP cable with RJ-45 connectors at both ends. An EIA/TIA-568
category 5 cable must be used for 100BASE-TX connectors to meet
various standards, including electromagnetic compatibility.
3
Connect the power cord to the server.
4
Secure the power-cord cable, keyboard cable, and mouse cable in the
strain-relief clamps.
Ÿ
Power cord in strain-relief clamp
.2/
.
Ÿ
Keyboard in strain-relief clamp
.3/
.
Ÿ
Mouse in strain-relief clamp
.4/
.
5
Connect all power cords to electrical outlets.
Important
After you plug the server power cord into an outlet and before you press
the power switch, the power-on light will blink to indicate that power is
present.
6
Continue with “4. Verifying Your Server Is Operating Properly” on page 14.
12
Netfinity 5000 Express Setup and Installation