IBM LS42 - BladeCenter - 7902, Руководство по установке

Страница: 20 / 56

Closing the blade server cover
Attention: You cannot insert the blade server into the BladeCenter unit until the
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
The following illustrations show how to close the cover on a blade server. These
instructions also apply to closing the cover on an MPE or expansion unit.
To close the blade server cover, complete the following steps:
1. Before you begin, read “Safety” on page v and “Installation guidelines” on
page 1.
2.
Lower the blade cover so that the slots at the rear slide down onto the pins at
the rear of the blade server, as shown in the illustration. Before closing the
cover, make sure that all components are installed and seated correctly and that
you have not left loose tools or parts inside the blade server.
3. Pivot the cover to the closed position, as shown in the illustration, until it clicks
into place.
10
IBM BladeCenter: LS42 Multiprocessor Expansion Unit