IBM J02M, Быстрый старт

Страница: 13 / 32

Figure 5: Rear of the IBM Ethernet Router J02M
You must remove the following components before you lift the router:
■
Dense Port Concentrators (DPCs)
■
Physical Interface Cards (PICs)
■
Flexible PIC Concentrators (FPCs)
■
Switch Control Boards (SCBs) including the installed Routing Engines
■
Power supplies
■
Fan tray
NOTE: The air filter weighs only 1 pound. Therefore, it is not necessary to remove
it.
To remove the components from the router:
1.
Slide each component out of the chassis evenly so that it does not become stuck
or damaged.
2.
Label each component as you remove it so you can reinstall it in the correct
location.
3.
Immediately store each removed component in an electrostatic bag.
4.
Do not stack removed components. Lay each one on a flat surface.
NOTE: For complete instructions about removing router components, see “Installing
the Router Without a Mechanical Lift” in the IBM Ethernet Router J02M Hardware
Guide .
Step 3: Install the Router
■ 11
Step 3: Install the Router