IBM iSeries 5075, Настройка

Страница: 13 / 49

Powering down your system unit
You must power down your system unit before you install your 5075.
__ 1. If you have logical partitions on your system unit, refer to the AS/400
Information Center to find instructions on powering down a system with
partitions.
__ 2. Ensure that all jobs are complete.
__ 3.
When all jobs are complete, type
pwrdwnsys *immed
on an AS/400 command
line and press the Enter key.
__ 4. After your system unit has completely powered down, power off all PCs
and devices, such as printers and display stations, that are connected to it.
__ 5. Unplug any power cords, such as for printers, expansion units, and display
stations, that are connected to your system unit.
__ 6. Unplug the power cord for your system unit from the electrical outlet.
__ 7. Did you receive a 7002 internal flex cable with your 5075?
Yes No
↓
Go to “Chapter 2. Installing your 5075 directly to your system unit”
on page 7 or “Chapter 3. Connecting your 5075 to another
expansion unit” on page 9.
__ 8.
Go to “Installing the 7002 cable”.
Installing the 7002 cable
If your 5075 came with the 7002 internal flex cable, you need to install it into your
AS/400 270 before you can set up your 5075. To install the 7002 cable follow these
steps:
__ 1. Remove the right side cover (view from back):
__ a.
Loosen the screws.
__ b. Slide the cover from front to back until it stops.
__ c.
Pull the cover out.
Figure 2. Planning for redundant link with two expansion units
Chapter 1. Preparing to set up your 5075 Expansion Unit
3