IBM eServer BladeCenter JS20 Type 8842, Инструкция по установке и эксплуатации

Страница: 88 / 150

Checkpoint code Description Suggested action
E217 Setup DMA address re-mapping logic
(DART), HIL base, and storage
description register 1 (SDR1).
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E218 Copy the set of flash RAM to
memory.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E219 Save the dual in-line memory module
(DIMM) serial presence detects
(SPDs) and the processor status and
presence.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E21A Running code from memory.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E21B Load PFW into memory.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E21C Run HyperTransport (HT)
initialization.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E21D Run PCI initialization.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E21E Run I/O advanced programmable
interrupt controller (APIC)
initialization.
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E21F Building the partition fundamental
data structure (PFDS).
1. Perform the system checkout procedure. See
“System checkout” on page 58.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
E2B0 Reserved No action is required.
E2B1 Reserved No action is required.
72
BladeCenter JS20 Type 8842: Installation and User’s Guide