IBM eServer BladeCenter HS20Type 8832, Инструкция по установке и эксплуатации, Страница: 49 / 112

8. Close the blade server cover (see “Closing the blade server cover” on page
36).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
9. Reinsert the blade server into the bay in the BladeCenter unit.
10. Turn on the blade server.
11. Start the blade server Configuration/Setup Utility program and set configuration
parameters as needed (see “Using the Configuration/Setup Utility program” on
page 43 for information).
Completing the installation
To complete the installation, complete the following tasks. Instructions for each task
are in the following sections.
1. Reinstall the blade server bezel assembly, if you removed it (see “Installing the
blade server bezel assembly” on page 36).
2. Close the blade server cover, unless you installed an expansion unit option (see
“Closing the blade server cover” on page 36).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
3. Reinstall the blade server into the BladeCenter unit (see “Installing the blade
server in the BladeCenter unit” on page 37).
4. Turn on the blade server (see “Turning on the blade server” on page 15).
5. For certain options, run the blade server Configuration/Setup Utility program
(see “Updating your blade server configuration” on page 40).
Note: If you have just connected the power cords of your BladeCenter unit to
electrical outlets, you must wait until the power-on LED on the blade server
flashes slowly before pressing the power-control button on a blade server.
Chapter 3. Installing options
35