IBM eServer BladeCenter HS20Type 8832, Инструкция по установке и эксплуатации, Страница: 37 / 112

Removing the blade server bezel assembly
To install certain options, you must first remove the blade server bezel assembly.
The following illustration shows how to remove the bezel assembly from the blade
server.
Control panel
connector
Bezel-assembly
release
Bezel-assembly
release
Control-panel
cable
Complete the following steps to remove the blade server bezel assembly:
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 19.
2. Open the blade server cover (see “Opening the blade server cover” on page 22
for instructions).
3. Press the bezel-assembly release and pull the bezel assembly away from the
blade server approximately 1.2 cm (0.5 inch).
4. Disconnect the control-panel cable from the control-panel connector.
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.
Installing an IDE drive option
Your blade server has two connectors on the system board for installing an optional
2.5-inch HS20 IDE Hard Disk Drive or BladeCenter Flash Disk Drive.
Note: In this document, both types of drives are referred to as IDE drives.
Each IDE connector is on a separate bus. Depending on your blade server, at least
one IDE hard disk drive might already be installed. If your blade server is equipped
with one IDE hard disk drive, you can install an additional IDE hard disk drive.
These two IDE hard disk drives can be used to implement and manage redundant
array of independent disks (RAID) level-1 under both the Linux and Microsoft
Windows 2000 operating systems. See “Configuring an IDE RAID” on page 52 for
information about IDE RAID configuration.
Attention: To maintain proper system cooling, do not operate the system unit
without either a blade server, expansion unit, or filler blade installed in each blade
bay for more than 1 minute for the BladeCenter unit and 20 minutes for the
BladeCenter T unit.
Chapter 3. Installing options
23