IBM eserver 7210, Руководство по настройке и эксплуатации

Страница: 21 / 38

Step 6. Placing the 7210 DVD-RAM Drive
The 7210 DVD-RAM Drive can be located anywhere that is convenient to your
system unit. The only restrictions are the length of the power cord and the SCSI
cable. Recommended locations are:
v
Away from the floor
v
In a horizontal position
v
Where the DVD disc can be easily inserted
To place the 7210 DVD-RAM Drive, do the following:
1.
__ Set the 7210 DVD-RAM Drive in the location that you have previously
determined.
2. __ Connect the power cable to the 7210 DVD-RAM Drive. (Do not plug it
into the electrical outlet at this time.)
The external devices that attach to the system unit can be stacked. The 7210
DVD-RAM Drive should be placed at the top of the stack.
Step 7. Performing a System Shutdown
Attention: Do not attach the 7210 DVD-RAM Drive to an active system unit. This
can damage the 7210 DVD-RAM Drive, the system unit, or both.
To perform a system shutdown, do the following:
Note:
Before doing a controlled shutdown of the system unit, notify other users
who may be using the system.
1. __ If it is on, perform a controlled shutdown of the system as follows:
For RS/6000 or pSeries Systems
: To do a fast shutdown, type
shutdown -F
from the console. (You must have root authority to do the shutdown; see your
system administrator.) Depending on the host system configuration, the
shutdown may take several minutes. When the message Halt Completed
displays on the console, continue with step 2.
For AS/400 or iSeries Systems: For instructions about performing a controlled
shutdown, refer to the host system documentation, then return here and
continue with step 2.
2.
__ When the shutdown is complete, turn off the power to the system unit.
3. __ Turn off the power to all external devices connected to the system unit.
DANGER
An electrical outlet that is not correctly wired could place hazardous
voltage on metal parts of the system or the products that attach to the
system. It is the customer’s responsibility to ensure that the outlet is
correctly wired and grounded to prevent an electrical shock. (RSFTD201)
4. __ Unplug the power cables to all external devices from their electrical outlets.
5. __ Unplug the system unit power cable from the electrical outlet.
Chapter 2. Setting Up
7