Chapter 2. Installing options
23
Complete the following steps to install an U-bolt.
1. Review the safety precautions listed in Statement 1 and Statement 5 in “Safety” on
page v.
2. Turn off the server and peripheral devices and disconnect all external cables and
power cords; then, remove the cover (see “Removing the side cover” on page 6 for
details).
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the U-bolt through the rear panel; then, attach and tighten the nuts.
5. Replace the side cover, see “Installing the cover”.
6. Thread the cable through the U-bolt and around an object that is a part of or
permanently secured to the building structure or foundation, and from which it
cannot be removed; then, fasten the cable ends together with a lock.
7. Reconnect the external cables and power cords, and turn on the peripheral
devices and the server.
Installing the cover
The following information describes the cover installation procedure.
Notes:
1. The illustrations in this document might differ slightly from your hardware.
2. If you removed the support bracket assembly after you removed the cover,
reinstall it before you install the cover. See “Removing the support bracket
assembly” on page 7 for details.
Содержание eServer 200 xSeries
