IBM Deskstar 120 GXP, Технические характеристики

Страница: 82 / 211

8.1 Alternate Status Register
ERR IDX COR DBQ
DSC/
SERV
DF RDY BSY
0 1 2 3 4 5 6 7
Alternate Status Register
Figure 69. Alternate Status Register
This register contains the same information as the Status Register. The only difference is that reading this
register does not imply interrupt acknowledge or clear a pending interrupt. See 8.13, “Status Register” on
page 72 for the definition of the bits in this register.
8.2 Command Register
This register contains the command code being sent to the device. Command execution begins immedi-
ately after this register is written. The command set is shown in Figure 88 on page 104.
All other registers required for the command must be set up before writing the Command Register.
8.3 Cylinder High Register
This register contains the high order bits of the starting cylinder address for any disk access. At the end of
the command this register is updated to reflect the current cylinder number.
In LBA Mode this register contains Bits 16-23. At the end of the command this register is updated to reflect
the current LBA Bits 16-23.
The cylinder number may range from zero to the number of cylinders minus one.
8.4 Cylinder Low Register
This register contains the low order bits of the starting cylinder address for any disk access. At the end of
the command this register is updated to reflect the current cylinder number.
In LBA Mode this register contains Bits 8-15. At the end of the command this register is updated to reflect
the current LBA Bits 8-15.
The cylinder number may be from zero to the number of cylinders minus one.
Deskstar 120GXP hard disk drive specifications
68