IBM BladeCenter HC10 Type 7996, Инструкция по установке и эксплуатации, Страница: 45 / 74

v
Startup Option
Select this choice to view or change the start options. Changes in the start
options take effect when you start the blade workstation.
You can set keyboard operating characteristics, such as keyboardless operation,
or specify whether the blade workstation starts with the keyboard number lock on
or off.
You can specify how or whether the blade workstation restarts when power is
restored.
You can enable a virus-detecting test that checks for changes in the boot record
when the blade workstation starts.
– Startup Sequence Options
Select this choice to view the Startup Sequence menu. The startup sequence
specifies the order in which the blade workstation checks devices to find a
boot record. The blade workstation starts from the first boot record that it
finds.
v
Advanced Setup
Select this choice to change values for advanced hardware features, such as
CPU options and PCI configuration.
Important: The blade workstation might malfunction if these settings are
incorrectly configured. Follow the instructions on the screen carefully.
This choice is on the full Configuration/Setup Utility menu only.
– CPU Options
Select this choice to view or change the microprocessor options.
– PCI Bus Control
Select this choice to view or change the system resources that are used by
the installed PCI or PCI Express devices.
– Baseboard Management Controller (BMC) Settings
Select this choice to view the baseboard management controller (BMC)
information and to change some items. You can enable or disable the BMC
watchdog timer and enable or disable clearing the system event/error log.
- BMC Network Configuration
Select this choice to view and change the BMC network configuration.
- BMC COM Port Sharing/Configuration
Select this choice to enable or disable serial port sharing and specify the
serial port access mode.
- System Event Log
Select this choice to view all entries in the system event/error log since the
log was last cleared.
– Compression Card Network Configuration
Select this choice to view or change the IP address, subnet mask, or gateway
of the compression card.
v Error Logs
Select this choice to view or clear error logs.
– POST Error Log
Select this choice to view the three most recent error codes and messages
that were generated during POST.
Chapter 4. Configuring the blade workstation
33