IBM BladeCenter HC10 Type 7996, Инструкция по установке и эксплуатации, Страница: 34 / 74

Completing the installation
To complete the installation, complete the following tasks. Instructions for each task
are in the following sections.
1. Reinstall the blade workstation bezel assembly, if you removed it (see “Installing
the blade workstation bezel assembly” for information on installing the bezel
assembly).
2. Close the blade workstation cover (see “Closing the blade workstation cover” on
page 23).
Statement 21:
CAUTION:
Hazardous energy is present when the blade is connected to the power
source. Always replace the blade cover before installing the blade.
3. Reinstall the blade workstation into the BladeCenter unit (see “Installing the
blade workstation in a BladeCenter unit” on page 24).
4. Turn on the blade workstation (see “Turning on the blade workstation” on page
11).
5. For certain optional devices, run the blade workstation Configuration/Setup
Utility program (see “Updating the blade workstation configuration” on page 25).
Note: If you have just connected the power cords of the BladeCenter unit to
electrical outlets, you must wait until the power-on LED on the blade
workstation flashes slowly before you press the power-control button.
Installing the blade workstation bezel assembly
The following illustration shows how to install the bezel assembly.
Control-panel connector
Control-panel cable
Bezel-assembly
release
Bezel-assembly
release
Bezel
To install the blade workstation bezel assembly, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 15.
2. Connect the control-panel cable to the control-panel connector on the system
board.
3. Carefully slide the bezel assembly onto the blade workstation until it clicks into
place.
22
BladeCenter HC10 Type 7996: Installation and User’s Guide