![IBM Aptiva Series Скачать руководство пользователя страница 96](http://html2.mh-extra.com/html/ibm/aptiva-series/aptiva-series_hardware-maintenance_4025256096.webp)
Check Procedures 2-43
Monitor
First, set the system to VGA mode. To do this in Windows 95, depress
the F8 function key during startup. Safe mode (VGA) will be set for
Windows 95. Use the operating system's video setup to change the
monitor resolution.
The monitors that come with the system are DDC2A/B (Display Data
Channel) compliant. While Windows 95 comes up, the DDC2 monitor
passes resolution and frequency information to the system. The
system interprets the data and sets up the proper refresh rate.
If the monitor type is set to the power saving mode, the screen
remains black and the LED lights or flashes in amber color. When the
monitor is turned-on alone, or is turned-on and connected to a
powered-off system unit, the monitor LED presents amber blinking.
Under the normal operation conditions, the LED lights in green color.
Note: Some monitors have a detachable system I/O signal cable
between the monitor and the system unit. Check the line
voltage, power cord, and continuity for the system I/O signal
cable before replacing the monitor. See "Monitor Port Signals”
on page 5-17 for pin identification.
001 - START
−
Power-off the system unit and monitor.
−
Remove all adapter cards from the riser card.
−
Make sure the monitor I/O signal cable is properly connected to the
system unit and monitor.
−
Make sure the power cords are properly connected to the system
unit and monitor, and that the line voltage is correct. See "Power
Supply" on page 2-32.
−
Make sure the monitor contrast and brightness controls are not
turned too low.
−
Make sure the Bootable Diagnostics Diskette is in the diskette
drive.
−
Power-on the monitor, and wait 20 seconds.
−
Power-on the system unit.
Note:
If the monitor was not sold together with the system unit, you
may need to refer to the service information provided with the
monitor.
Содержание Aptiva Series
