IBM 8960-F96, Инструкция по установке, обслуживанию и эксплуатации

Страница: 43 / 116

1. Extension brackets
2. Screws, 8-32 x 5/16-in., flathead Phillips
Installing the device in the rack
About this task
Complete the following steps to install the device in the rack.
Procedure
1. Position the device in the rack, as shown in Figure 11 on page 24, providing temporary support under
the device until the rail kit is secured to the rack.
2.
Attach the right front bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws
and two retainer nuts. Use the upper and lower holes in the bracket.
3. Attach the left front bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and
two retainer nuts. Use the upper and lower holes in the bracket.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
Figure 10. Attaching the bracket extensions to the device
Mounting the switch
23